The Y-cable plug (1) must be guided to the front in the
cockpit area. The second Y-cable socket (2) should come
out on the left side of the fuselage.
Push the left wing (1) as far as necessary onto the wing
connector such that the servo cable plug can be connect-
ed to the Y-cable socket (2).
Pay attention to the polarity of the plugs again.
Then sensitively push the two wings together and carefully
pull the Y-cable connector (3) so that the Y-cable is not
pinched between the wings.
If necessary, you can use a little foam adhesive to better
fix the servo cables in the groove (4).
Figure 7
Figure 8
59