Connecting The Aileron Servos - Reely Wild Hawk 3.0 Bedienungsanleitung

f) Connecting the aileron servos
It is advisable to lay the Y-cable (1) under the support plate
of the servos (2) so that it does not impair the functionality
of the two tail unit servos.
Then insert the Y-cable plug into the free output 1 of the
receiver (3).
Pay attention to the correct alignment of the plug (see
above) and follow the other plugs, which are all connected
in the same orientation.
The double-sided adhesive tape can be used to attach the
receiver (1) to the fuselage side wall.
The antenna (2) is guided to the outside through a small
opening made with the help of a thin wire.
Use a few more strips of adhesive tape to attach the an-
tenna cable (3) to the fuselage side wall. Ensure the trans-
mitter is not mounted too high so that you can properly put
on the canopy.
Important!
Do not guide the antenna in the fuselage. The
current-carrying wires can cause radio shad-
ows and thus disturb signal transmission.
The model can be made ready for use after
configuring the remote control.
Figure 11
Figure 12
61