First Landing - Reely Wild Hawk 3.0 Bedienungsanleitung

Elevator trim:
If the model tends automatically to ascend, repeatedly press the trim button for the elevator (see also Figure 13, no. 2)
upwards (see white arrows in Figure 34). Continue pressing the button until the model no longer tends to ascend. If
the model tends to fly downwards, press the trim button downwards (see dark arrows in Figure 34).
Figure 34
e) First landing
As with the take-off, the landing must always take place against the wind. To reduce altitude, you can fly large flat
circles with no motor power. Do not pull the elevator joystick too hard so that the model does not become too slow.
Select the last curve before the approach for a landing so that in case of an emergency you would have sufficient
room for landing and so that you would not have to correct the course significantly during the approach for a landing.
If the model seems to drop altitude a little too quickly, simply switch on the motor in low power mode. The last part of
the landing approach should be carried out with the motor switched off. Hold the model with the elevator in horizontal
position and wait until it drops altitude.
When the model is approx. 50 cm off the ground, begin carefully to pull the elevator joystick harder such that the tip of
the fuselage is not raised too much. The model will slow down steadily until it finally lands gently.
Upon landing, firstly unplug the flight battery from the model and then switch off the transmitter. Use a LiPo checker
to check the remaining charge of the flight battery. It should not be less than 30%. A deep discharge can permanently
damage the flight battery.
If necessary, you can readjust the rudder, elevator and aileron linkages such that the model flies straight and set the
digital trim on the transmitter back to the centre position.
79