Pairing Function; Maintenance And Cleaning - Reely Wild Hawk 3.0 Bedienungsanleitung

16. Pairing function

To ensure that the 2.4 GHz remote control can transmit a signal without interference, the remote control and receiver
must have the same digital code. The digital encoding (connection between the remote control and receiver) can be
configured using the pairing function.
The remote control and receiver are usually already paired when they leave the factory and can be used straight
away. The devices only need to be paired again if the remote control or receiver has been replaced or to correct a
malfunction.
To re-pair the receiver, proceed as follows:
• The transmitter and receiver must be in close proximity
to each other and away from any other 2.4 GHz trans-
mitters (Internet routers or similar hardware).
• Push the motor function joystick to the lowest position
and switch on the transmitter.
• Connect the flight battery to the model.
• Press and hold the pairing button (1) on the receiver
until the LED (2) flashes red. Upon releasing the button,
the receiver LED should light up green. The receiver is
now paired with the transmitter.
• Check whether the model responds correctly to the con-
trol commands from the transmitter.

17. Maintenance and cleaning

Check the rudder linkages and the control functions of the servos on your model regularly. All moving parts should
move freely, but there must be not any slackness in the bearing.
The motor should turn easily by hand and the propeller should not be damaged or torn. Replace the worn propeller
with the included replacement propeller or order an original replacement propeller.
Cracks or breaks can be repaired with instant glue. However, the instant glue must be suitable for foam materials.
During repair work, always pay attention to the weight and use as little glue as necessary. When repairing the wing,
the model must eventually be balanced around the longitudinal axis. Trim weights must be placed in the lighter wing
such that the model is properly balanced.
It is not recommended to repair a defective servo or receiver. In this case, it is useful to replace the defective parts
with structurally identical ones.
Clean the exterior of the model and the remote control with a soft, dry cloth or brush. Never use aggressive cleaning
chemicals or detergents, as these may damage the surface of the boat.
Figure 36
81