C) Installing The Wings - Reely Phönix Bedienungsanleitung

Turn the clevis (1) to set the linkage rod length so that the elevator (2) is in its
neutral position.
When the rod is shortened properly, hook and attach the clevis to the medium
hole of the rudder horn (3).

c) Installing the Wings

Push the wing spar (1) into one half of the wing (2) as far as possible.
Connect the servo connection cables of the wing servos (1) to their respective
counterparts inside the fuselage (2).
Our advice: To prevent the plug connection from coming loose, use heat-shrink
tube or adhesive tape.
Verify the neutral position of the servo horn again as described under b) and
correct is as required.
Then push the wings together until the safety catch (3) engages.
When pushing together the two halves, ensure that none of the two servo cables
are squeezed!
Figure 6c
Figure 7a
Figure 7b
37