3M Elipar DeepCure-S Betriebsanleitung Seite 175

SEITE 173 - 148 x 210 mm - 3100021789/01 - SCHWARZ - 20-053 (kn)
Immunity test Compliance to IEC 60601 test levels Electromagnetic environment – guidance
Electrostatic dis- ± 8 kV contact
charge (ESD) ± 2 kV, ± 4 kV, ± 8 kV, ± 15 kV air
IEC 61000-4-2
Radiated RF EM fields 3 V/m
80 MHz - 2,7 GHz
80 % AM at 1 kHz
IEC 61000-4-3
Proximity fields from see following table:
RF wireless Test specifications for enclosure port
communications immunity to RF wireless communica-
equipment tions equipment
IEC 61000-4-3
Electrical fast tran- ± 2 kV for power supply lines
sients / bursts 100 kHz repetition frequency
IEC 61000-4-4
Conducted distur- 3 V
bances induced by RF
fields 0,15 MHz - 80 MHz
6 V in ISM bands between
0,15 MHz and 80 MHz
80 % AM at 1 kHz
IEC 61000-4-6
Surges ± 0,5 kV, ± 1 kV
Line-to-line
IEC 61000-4-5
Voltage dips, and 0 % U
short interruptions on At 0°, 45 °, 90°, 135°, 180°, 225°,
power supply input 270°, 315°
lines
0 % U
70 % U
Single phase: at 0°
0 % U
IEC 61000-4-11
Power frequency 30 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE U is the a. c. mains voltage prior to application of the test level..
T
rms
; 0,5 cycle
T
; 1 cycle and
T
; 25130 cycles
T
; 2501300 cycle
T
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30 %.
Mains power quality should be that of a
typical commercial or hospital environment.
Mains power quality should be that of a
typical commercial or hospital environment.
Mains power quality should be that of a
typical commercial or hospital environment. If
the user of the Elipar DeepCure-S Dental
Light Unit requires continued operation during
power mains interruptions, it is recommended
that the Elipar DeepCure-S Dental Light Unit
be powered from an uninterruptible power
supply or a battery.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
173