Lifted Hopper Door Support Rod Installation; Using The High-Pressure Water Gun (*) - Nilfisk RS 1301 Betriebsanleitung, Originalanleitung

LIFTED HOPPER DOOR SUPPORT ROD INSTALLATION

Before working under the lifted hopper door (44, Fig. G), it is necessary to install the support rod (17, Fig. F) according to the
following procedure.
Support rod installation
1. Remove the rod (17, Fig. F) from the housing and lift the door as necessary, then install the rod in the housing (18).
Support rod removal
2. Perform the procedures described in step 1 in the reverse order.

USING THE HIGH-PRESSURE WATER GUN (*)

(*) Optional
The machine is equipped with a high-pressure water system (optional) to be used for washing the machine or other purposes.
WARNING!
If the water level in the tanks is insuffi cient for an interval of 10 seconds or more, the high pressure pump does
not turn on or stops the water delivery.
The following procedure refers to the high-pressure water gun use.
1. Open the left upper side door (9, Fig. G) by disengaging the relevant fasteners (10) with the supplied key and pick up the high-
pressure water gun (39, Fig. F).
2. Withdraw part of the hose (21, Fig. F) and connect the gun (9, Fig. E) to the quick coupling (22, Fig. F).
3. Start the diesel engine at idle speed, as shown in the relevant paragraph.
WARNING!
If the engine speed exceeds 2,050 rpm, the high pressure pump does not turn on or stops the water delivery. If
the engine speed lowers to 1,900 rpm, the high pressure pump starts to deliver water again.
4. If pressed, release the switch (27, Fig. D).
5. Turn on the high-pressure pump by pressing the upper part of the switch (30, Fig. D).
6. If necessary, bleed the air from the system by turning the water gun knob completely counter-clockwise and by pressing the
water gun lever until the water comes out constantly and at low pressure.
Release the water gun lever and turn the knob clockwise to use the high pressure nozzle.
7. Run the engine at the desired speed.
8. Use the water gun by pressing the relevant trigger.
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
WARNING!
Do not run the high pressure pump for long periods without using the water gun.
9. After using the water gun, perform steps 1 to 5 in the reverse order.
USER MANUAL
RS 1301 33018310(3)2010-01 A
ENGLISH
33