Nilfisk RS 1301 Betriebsanleitung, Originalanleitung Seite 174

ENGLISH
7. If on, stop the side brooms, the 3rd broom and the suction fan by pressing the switches (29 and 30, Fig. D) on the upper part.
8. Get out of the machine and bring the 3rd broom safety pin from the position (2, Fig. M) (disengaged) to the position (1)
(engaged), by pulling and turning the relevant lever.
9. Start the engine as shown in the previous paragraph.
NOTE
Steps 4, 5, 6, 7, 8 and 9 not to be performed if the machine is stored as recommended.
10. Disengage the parking brake with the lever (13, Fig. E).
11. Gradually bring forward the engine throttle lever (16, Fig. E) and set the engine speed on the display (17, Fig. D) to 2,300 rpm.
NOTE
If 2,350 rpm are reached during transport, an over revving safety function cuts power to the engine, while the engine
speed on the display (17, Fig. D) fl ashes to indicate the abnormal condition.
12. Start to transport the machine, by keeping the hands on the steering wheel (28, Fig. D) and gradually pressing the pedal (26),
on the front side to move forward and on the rear side to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
WARNING!
To reverse the speed there is no need to stop the machine. When pressing the drive pedal in the reverse
direction, the system allows for a 1-second delayed reaction so that the machine slows down enough to avoid
dangerous manoeuvres.
WARNING!
The machine is equipped with a safety system that stops the movement (machine in neutral) and disables
the hydraulic functions when the operator is not on the driver's seat (14, Fig. E) for more than 3 seconds. The
movement and the hydraulic functions restarts automatically when the operator returns on the driver's seat (14).
Only the suction fan for the manual rear pipe, and the high-pressure pump for the washing system can be used
in these conditions.
Stopping the machine in transport mode
13. To stop the machine release the pedal (26, Fig. D).
To stop the machine quickly, press also the brake pedal (31).
14. Turn the engine throttle lever (16, Fig. E) to idle, and hold it in this position for a few minutes to let the system stabilize.
15. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
WARNING!
In case of immediate danger for the operator or other people, press the emergency push-button to stop the
engine. Do not use the emergency push-button to stop the engine under normal conditions.
16. Engage the parking brake with the lever (13, Fig. E).
24
USER MANUAL
33018310(3)2010-01 A RS 1301