Using The Camera Kit (Optional); Salt Spreader Use; Snow Brush Use - Nilfisk RS 1301 Betriebsanleitung, Originalanleitung

ENGLISH

USING THE CAMERA KIT (optional)

The video-camera system can be turned on manually or automatically with the drive pedal.
1. Manual activation
• When the machine is in "neutral" (drive pedal not pressed), to turn on the video system (1, Fig. BA) and the cameras (4
and 5), press the switch (2) when the ignition key (24, Fig. D) is inserted. The display shows the front and rear cameras
sequentially.
2. Automatic activation
• When the ignition key (24, Fig. D) is inserted, the video (1, Fig. BA) and the cameras (4 and 5) turn on when pressing the
drive pedal. The display shows the front or rear camera whether the pedal is pressed for forward or reverse gear.
3. For the functions of other switches on the display, refer to the camera kit Manual.

SALT SPREADER USE

1. Assemble the salt spreader (9, Fig. BD) according to the procedure shown in the relevant paragraphs.
2. Load suitable salt in the compartment (2, Fig. BD).
3. Adjust the salt fl ow with the control lever (1, Fig. BD).
4. To turn on the salt spreader, press the lower part of the switch (17, Fig. BD).
5. To start spreading salt, press the drive pedal.
6. To turn off the salt spreader, press the upper part of the switch (17, Fig. BD).
WARNING!
If the switch is pressed, the hopper lifting/switch is inhibited.
NOTE
When the machine stops, the salt spreading is stopped too.

SNOW BRUSH USE

1. Assemble the snow brush (Fig. AV) according to the procedure shown in the relevant paragraphs.
2. Lower and start the snow brush by pressing the lower part of the switch (17, Fig. BE).
3. To lift the snow brush, stop the snow brush by pressing the upper part of the switch (17, Fig. BE) and use the suction inlet
lifting/lowering controls.
4. Before using the snow brush (10, Fig. BE), check its height from the ground according to the following procedure.
• Drive the machine with the snow brush on a level ground.
• Keep the machine stationary, lower the snow brush completely and let it rotate for few seconds.
• Stop and lift the snow brush, then move the machine aside and engage the parking brake.
• Check that the snow brush print (20, Fig. BE), along its length, is 2 to 4 cm wide.
If the print is not within the specifi cations, remove the pins (13, Fig. BE) and adjust by lifting/lowering the wheels (11) with
the winches (12).
When the adjustment is completed, place the winches (12) in the original position and install the pins (13).
5. Engage the parking brake with the lever (13, Fig. E).
6. Tilt the snow brush assembly as necessary by using the suction inlet shifting controls (21 and 22, Fig. BE) on the joystick.
7. Now the machine is ready to operate with the snow brush.
If necessary, fi t snow chains on the front wheels of the sweeper.
WARNING!
After using the equipment, ensure that the snow brush is stopped by pressing the upper part of the switch (52,
Fig. D). If the switch is not released, the hopper lifting/dumping is inhibited.
34
USER MANUAL
33018310(3)2010-01 A RS 1301