Hopper Safety Support; Jacking The Machine; Machine Transport; Pushing/Towing The Machine - Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung

ENGLISH

HOPPER SAFETY SUPPORT

CAUTION!
Before performing any maintenance procedure under or near to the lifted hopper, pull the locking handle (39)
to make sure that the hopper safety support (5) is in place. The hopper safety support (5) holds the hopper
in the lifted position to allow work to be performed under the hopper. Never rely on the machine's hydraulic
components to safely support the hopper.

JACKING THE MACHINE

WARNING!
Never work under a machine without safety stands or blocks to support the machine.
When jacking the machine, do so at designated locations (do not jack on the hopper) - see jacking locations (8).

MACHINE TRANSPORT

WARNING!
Before transporting the machine on an open truck or trailer, make sure that:
– All access doors are latched securely.
– The machine is tied down securely.
– The parking brake is engaged.

PUSHING/TOWING THE MACHINE

CAUTION!
The hydraulic pump can be damaged if the machine is towed when the screw is in the normal working position
(locked).
The machine hydraulic pump (45) is equipped with a screw that disengages the traction system. The system prevents damage to
the hydraulic system when the machine is being towed/pushed short distances without using the engine.
1. To access the unlocking screw, open the engine compartment hood (1) by using the unlocking push-button (25) and locate the
hydraulic pump (45) in the front part of the engine (44).
2. Remove the supplied wrench (A, Fig. 1) on the pump lever.
3. With the wrench, turn the socket head screw (B) 1/4 of a turn counter-clockwise (C) to disengage the hydrostatic lock between
the engine and pump.
4. Tow or push the machine no faster than a normal walking pace (3-4.5 km/h) and for short distances only.
NOTE
If the machine is to be moved long distances the driving wheels need to be raised off the floor and placed on a suitable
transport dolly.
5. After pushing/towing the machine, turn the socket head screw 1/4 of a turn clockwise (D) to reset the hydrostatic lock and
hydraulic functions.
NOTE
If the screw is left in unlocking position (C), the hydraulic pump cannot drive the machine.
8
Downloaded from www.Manualslib.com
USER MANUAL
SR 1601 D3 / LPG3 / P3 - 33019216
manuals search engine
A
D
C
B
A
Figure 1
P100320