Maintenance; Scheduled Maintenance Table - Nilfisk RS 1301 Betriebsanleitung, Originalanleitung

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed when the machine is off (ignition key removed).
Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure.
NOTE
The display (17, Fig. D) is programmed to show an expired or nearly expired maintenance by means of the symbol
Maintenance must be performed at 150 and 500 hours (see Display Functions paragraph).
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance procedures see
the Service Manual that can be consulted at any Service Center.
For scheduled and extraordinary maintenance of the following optional equipment, refer to the relevant Manuals:
– Camera kit

SCHEDULED MAINTENANCE TABLE

Maintenance
Engine oil level check
Hydraulic system oil level check
Engine air fi lter cleaning
Air fi lter cyclone block cleaning
Engine radiator fi n cleaning/check
Engine coolant level check
Hydraulic system oil cooler fi n check
Battery fl uid level check
Hopper, fi lter and suction hose cleaning, gasket
check and fan bearing lubrication
Water nozzle and fi lter cleaning
Brake fl uid level check
Reverse gear buzzer operation check and
sensor adjustment
Diesel engine start-up safety system check
Engine fuel fi lter cleaning
Engine radiator fi n cleaning
Tyre pressure check
Suction inlet and skirt height and operation
check
Side broom position check and adjustment
3rd broom position check and adjustment
Hopper and suction hose gasket wear check
Coolant line check
Every 10 Every
After 50
hours or be-
hours
fore use hours
(1) (8)
RS 1301
USER MANUAL
Every Every
150 300 500
hours hours
(8)
(1)
(8)
33018310(3)2010-01 A
ENGLISH
.
Every Every
Long
1,000 2,000
periods
hours hours
37