Nilfisk RS 1301 Betriebsanleitung, Originalanleitung Seite 209

Problem
SUCTION INLET AND SKIRT
The suction inlet does not shift sideways.
The skirt opening force is not suffi cient.
The skirt does not open/close.
Lack of pressure in the cylinder because of worn gaskets.
The controls are directly activated from the sweeper control interface electronic board.
The sweeper control interface electronic board is powered, but shifting to the left is not being done.
The LED never turns off.
The LED will turn off properly when the machine control board issues the command.
The LED turns off properly and the interface electronic board is providing an output.
The LED on the connector is off.
The LED on the connector is on.
The sweeper control interface electronic board is powered, but shifting to the right is not being done.
The LED never turns off.
The LED will turn off properly when the machine control board issues the command.
The LED turns off properly and the interface electronic board is providing an output.
The LED on the connector is off.
The LED on the connector is on.
The skirt opening pressure is incorrect.
The operator is not on the driver's seat.
The operator is on the driver's seat but the control is not turned on.
Voltage is being supplied to the push-buttons, but the command is not carried out.
The push-buttons are working.
The fuse F02 is intact.
There is not positive activation of K12/K13.
There is positive activation of K12/K13.
Relay K12/K13 is intact and is properly turned on.
The LED on the connector is off.
The LED on the connector is on.
RS 1301
USER MANUAL
Possible cause
33018310(3)2010-01 A
ENGLISH
59