Qualified Technical Personnel - SKF TLMR 101 Originalbetriebsanleitung

1. Safety instructions
○ Protective and safety mechanisms cannot
be removed, modified, or disabled during
operation and must be checked for pro-
per function and completeness at regular
intervals.
If protective and safety mechanisms must
be removed, they must be installed im-
mediately following conclusion of work
and then checked for proper for proper
function.
○ Any malfunctions that occur must be
resolved according to responsibility. The
operator of the system/ machine must be
notified in case of malfunctions outside
the scope of responsibility.
○ Wear personal protective equipment.
○ Observe the particular safety data sheets
when handling lubricants.

1.3 Qualified technical personnel

Only qualified technical personnel may ins-
tall, operate, maintain, and repair the pro-
ducts described in this document.
Qualified technical personnel are persons
who have been trained, assigned, and inst-
ructed by the operator of the final product
into which the described product is
incorporated.
Such persons are familiar with the
relevant standards, rules, accident preventi-
on regulations, and assembly conditions
as a result of their training, experience,
and instruction. They are qualified to carry
out the required activities and in doing so
recognize and avoid any potential hazards.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in DIN VDE 0105
and IEC 364.
Relevant country-specific definitions of qua-
lified technical personnel apply for countries
outside the scope of DIN VDE 0105 or IEC
364. The core principles of these country-
specific qualification requirements for
technical personnel cannot be below those
of the two standards mentioned above.
The operator of the final product is respon-
sible for assigning tasks and areas of
responsibility and for the responsibility and
monitoring of the personnel. These areas
must be precisely specified by the operator.
The personnel must be trained and instruc-
ted if they do not possess the requisite
knowledge.
Product training can also be performed by
SKF in exchange for costs incurred.
EN
1
9