Mount The Cartridge - SKF TLMR 101 Originalbetriebsanleitung

6. Assembly

6.17 Mount the cartridge

Mount the cartridge
• Remove protective screw (6) from lubri-
cator and keep it for later use.
• Remove closure screw (7) of the
cartridge.
• Eliminate contaminations in the area
around the cartridge and the grease inlet
of the driving unit.
• Turn cartridge (2) into the TLMR by hand
until it stops.
Remove the cartridge
• Turn used cartridge (2) clockwise out of
the TLMR.
• Check sealing ring (1.5), replace defective
sealing ring.
• Turn in new cartridge as described and
carry out the reset, if necessary, change
the size of the cartridge.
or
• Turn protective screw (6) into the
lubricator.
• Switch off the TLMR.
Protective screw Fig. 15
6
Closure screw Fig. 16
2 7
Eliminate contamination Fig. 17
1.5
EN
Check the seal Fig. 18
1.5
Dispose of cartridge Fig. 19
EWC-CODE: 15 01 10
29
6