14 6.1 General Information; 14 6.2 Set-Up And Attachment - SKF TLMR 101 Originalbetriebsanleitung

EN
6. Assembly
6.1 General information
Only qualified technical personnel may
install, operate, maintain, and repair the
progressive feeders described in the lifecycle
manual. Qualified technical personnel are
persons who have been trained, assigned,
and instructed by the operator of the final
product into which the progressive feeders
are incorporated.
Such persons are familiar with the relevant
standards, rules, accident prevention regu-
lations, and operating conditions as a result
of their training, experience, and instruction.
They are qualified to carry out the required
activities and in doing so recognize and
avoid potential hazards.
22
Before assembling/ setting up the product,
the packaging material and any shipping
braces (e.g. plugs) must be removed.
The packaging material must be preserved
until any discrepancies are resolved.
ATTENTION
Observe the technical data (chapter 4).
6.2 Set-up and attachment
The product should be protected against hu-
midity and vibration and should be installed
in an easily accessible position to ensure all
other installations can be carried out without
any problem. For indications on the maxi-
mum admissible ambient temperature see
the technical data. During assembly and du-
ring any drilling work, always pay attention
to the following:
○ Other units must not be damaged by as-
sembly work.
○ The product must not be installed within
the range of moving parts.
○ The product must be installed at an ade-
quate distance from sources of heat and
coldness.
○ Maintain safety clearances and comply
with local regulations for assembly and
accident prevention.
6. Assembly