Ryobi RBC30SESC Bedienungsanleitung Seite 24

DESCRIPTION
1. Primer Bulb
2. Choke lever
3. Fuel Cap
4. Starter Grip
5. Throttle Lock
6. On / Off Switch
7. Throttle Trigger
8. Rear Handle (RBC30SESC)
9. Front Handle (RBC30SESC)
10. Harness
11. Shaft
12. Blade Guard
13. Tri-arc Blade
14. Grass Defl ector
15. Cutting Line
16. Idle Speed Screw
17. Knob
18. Hanger Cap
19. Trigger Handle (RBC30SBSC only)
20. Left Handle (RBC30SBSC only)
21. Throttle interlock (RBC30SBSC only)
22. Reel Easy TM
23. Latch
24. Bolt (RBC30SBSC only)
25. Clamp (RBC30SBSC only)
26. Wrench
27. Bracket (RBC30SBSC only)
28. Bike handle (RBC30SBSC only)
29. Combination wrench
30. Clamp
31. Screw
32. Bracket (RBC30SESC only)
33. Securing bolt (RBC30SESC only)
ASSEMBLY
UNPACKING
The product requires assembly.
■ Carefully remove the tool and any accessories from
the box. Make sure that all items listed in the packing
list are included.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
PACKING LIST
■ Power head with upper boom assembly x 1
■ Lower boom with string head assembly x 1
■ Ergo handle assembly x 1 (RBC30SESC only)
English (Original instructions)
■ Blade guard
■ Grass deflector
■ Blade with cover x 1
■ Harness x 1
■ Operator's manual x 1
■ Figure sheet x 1
■ Nut x 1
■ Washer x 1
■ Engine oil x 1
■ Combination wrench x 1
■ Wrench x 1
ATTACHING THE HANDLE
(Fig. 2a)
RBC30SBSC
■ Loosen the bolts with wrench and remove the clamp.
■ Place the handle bar in the plastic bracket located on
■ Replace the clamp and bolts back onto the bracket.
■ Adjust the handle bar for best operator control and
22
WARNING
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
the shaft housing.
Note: The throttle trigger must be mounted to the
operator's right side.