Herunterladen Diese Seite drucken

Raising Or Lowering The Cot With One Operator - Stryker Performance-PRO XT Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Performance-PRO XT:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 175
English
Raising or lowering the cot with two operators (Continued)
EN
To raise or lower the cot:
From the head end and foot end
1. Operator 1 (at the foot end): Squeeze the release
handle with a secure grip on the lifting bars.
2. Both operators:
a. Lift the foot end of the cot until you lift the weight
off of the latching mechanism.
b. Operator 1 (at the foot end): Squeeze and hold
the release handle while both operators raise or
lower the cot together.
c. Operator 1 (at the foot end): Release the release
handle when you reach the desired height.
d. Maintain a secure grip on the litter frame until the
latching mechanism locks into place.

Raising or lowering the cot with one operator

You can raise or lower an unoccupied cot into a vehicle with one operator.
WARNING
Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near
the base tubes while you raise or lower the cot.
Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you
load or unload the cot or change cot height position.
Always remove your foot from the base tube when you are lowering the cot to the lowest position.
Always keep hands away from the foot end release handle when you raise or lower the cot with the side release
handle.
1-22
Operation
From the left side and right side
1. Check the cot to determine if the side release handle
is on the patient left or patient right side.
2. Operator 1 (on the side with the release handle):
Reach the release handle at the midpoint of the litter.
3. Both operators:
a. Lift the foot end of the cot until you lift the weight
off of the latching mechanism (approximately 1/
4").
b. Operator 1 (on the side with the release handle):
Squeeze and hold the release handle.
c. Raise or lower the cot.
d. Operator 1 (on the side with the release handle):
Release the release handle when you reach the
desired height.
e. Maintain a secure grip on the litter frame until the
latching mechanism locks into place.
6086-209-005 REV G
www.stryker.com

Quicklinks ausblenden:

Werbung

loading