Herunterladen Diese Seite drucken

Adjusting Restraint Straps - Stryker Performance-PRO XT Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Performance-PRO XT:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 175
English
Securing the patient with the G-rated restraint straps (Continued)
EN
Installing the shoulder, thigh, or ankle restraints
To install the shoulder, thigh, or ankle restraints:
1.
Wrap the restraint strap around the cot frame.
2.
Push the restraint strap buckle through the loop.
3.
Pull the buckle around the loop to secure the restraint strap to the cot.
Figure 1-11: Wrap the restraint
strap around the cot frame
Installing the waist restraints
To install the waist restraints:
1.
Wrap the restraint strap around the cot frame.
2.
Push both buckles through the loop for the double buckle strap.
3.
Push the buckle and the tongue through the loop for the tongue and buckle strap.
4.
Pull the buckle through the loop to secure the restraint strap to the cot.
Note: The waist restraint must form an X with the restraint strap at the shoulder.

Adjusting restraint straps

Open the restraint straps and place them at either side of the cot while you position the patient on the cot mattress.
Lengthen the restraint straps, buckle them around the patient, and shorten them to tighten.
To open the restraint strap, press the red button on the front of the buckle receiver. This allows you to release the
buckle latch plate and pull it out of the receiver.
To close the restraint strap, push the latch plate into the receiver until you hear a click.
To lengthen the restraint strap, grasp the buckle latch plate, turn it at an angle to the webbing, then pull it out. A
hemmed tab at the end of the webbing prevents the latch plate from coming off of the strap.
To shorten the restraint strap, grasp the hemmed tab and pull the webbing back through the latch plate to tighten.
When you buckle a restraint strap around a patient, secure the latch plate and remove any loose webbing from the cot.
Inspect the restraint straps at least once a month (more if used often). Check for a bent or broken receiver or latch plate,
or torn or frayed webbing. Replace any worn or inoperable restraint strap.
1-32
Operation
Figure 1-12: Push the restraint
strap buckle through the loop
6086-209-005 REV G
Figure 1-13: Secure the restraint
strap to the cot
www.stryker.com

Quicklinks ausblenden:

Werbung

loading