Loading Or Unloading A Cot With The Power-Load Option; Loading A Cot Into A Vehicle With An Antler Style Cot Fastener - Stryker Performance-PRO XT Bedienungsanleitung

Raising or lowering the cot with one operator (Continued)
To raise or lower the cot:
From the foot end
1. Grasp the lower foot end lift tube.
2. Tip the cot up on its load wheels.
3. Squeeze and hold the release handle and raise or
lower the cot.
4. Release the release handle when you reach the
desired height.
5. Lower the cot back on onto the four base wheels.

Loading or unloading a cot with the Power-LOAD option

The cot is fully compatible with the Model 6390 Power-LOAD system if you ordered the cot with the Power-LOAD option
or upgraded your cot with the compatibility kit.
WARNING
• Always use Power-LOAD with the 6085/6086 Performance-PRO XT, 6500/6506 Power-PRO XT, and 6510/6516
Power-PRO IT cots with the Power-LOAD option only. In certain situations, you can use Power-LOAD as a standard
antler for most X-frame cots, but a rail clamp assembly is required for all cots without the Power-LOAD option.
• Always make sure that you use a Power-LOAD date of manufacture cot with the Stryker Model 6390 Power-LOAD
system to avoid the risk of injury.
Cot
Model 6506 Power-PRO XT
Model 6516 Power-PRO IT
Model 6086 Performance-PRO XT
For more information about using your Power-LOAD compatible cot, see the Power-LOAD operations manual.

Loading a cot into a vehicle with an antler style cot fastener

Always load an occupied cot with a minimum of two trained operators. Two operators must be present when a cot is
occupied. Operators must be able to lift the total weight of the patient, cot, and any items on the cot.
WARNING
• Always support the load of the patient, cot, and accessories after the weight is off of the ground.
• Two operators must be present when a cot is occupied.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you
load or unload the cot or change cot height position.
www.stryker.com
Operation
From the side
1. Place one foot on the outer base tube.
2. Grasp the side release handle with one hand. Place
your other hand on the outer support rail to stabilize
the cot.
3. Squeeze and hold the release handle and raise or
lower the cot.
4. Release the release handle when you reach the
desired height.
Compatibility kit
6506-700-001
6516-700-001
6086-700-001
6086-209-005 REV G
English
EN
1-23