Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attaching an oxygen bottle to the oxygen bottle holder
CAUTION
•
Do not load the oxygen bottle holder above the safe working load of 15 lb (6.8 kg).
•
Do not use two oxygen bottle holders at the same time.
To attach an oxygen bottle to the oxygen bottle holder:
1.
Place an oxygen bottle in the holder.
2.
Insert the lower strap through the buckle and affix the strap onto itself to secure the oxygen bottle to the holder.
Notes
•
Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always
place the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
•
Inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.
Attaching an oxygen bottle to the retractable head section oxygen bottle holder
WARNING
Do not pinch your fingers between the fowler bracket and the oxygen bottle if your cot is equipped with the optional
retractable head section oxygen bottle holder.
CAUTION
•
Do not load the oxygen bottle holder above the safe working load of 15 lb (6.8 kg).
•
Do not use two head end oxygen bottle holders at the same time.
To attach an oxygen bottle to the retractable head section oxygen bottle holder
1.
Center the oxygen bottle on the cradled surface of item (A).
2.
Tighten both straps (B) around the oxygen bottle.
3.
Secure the slack on the straps to the Velcro® on the straps.
www.stryker.com
Operation
(Figure 1-34 on page
6086-209-005 REV G
English
EN
1-44):
1-43
Quicklinks ausblenden:
Werbung
Kapitel
