Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Always read and strictly follow the warnings and cautions listed on this page. Service only by qualified personnel.
EN
WARNING
•
Install the cot fastener by qualified personnel only. Improper installation could result in injury to the patient or
operator.
•
Always make sure that all cots meet the installation specifications for the Stryker cot fastener system.
•
Do not allow untrained assistants to assist in the operation of the product.
•
Do not ride on the base of the cot.
•
Do not transport the cot sideways to avoid the risk of tipping. Always transport the cot in a lowered position, head
end or foot end first to minimize the risk of tipping.
•
Do not leave a patient unattended. Hold the product while a patient is on the product.
•
Do not apply a wheel lock when a patient is on the product or when you move the product to avoid the risk of tipping.
•
Do not use siderails as a patient restraint device.
•
Always transport the cot at a lower height to reduce the risk of a cot tip. If possible, obtain additional assistance or
take an alternate route.
•
Always avoid high obstacles, such as curbing, steps, or rough terrain to avoid the risk of the product tipping over.
•
Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near
the base tubes while you raise or lower the cot.
•
Always keep hands away from the foot end release handle when you raise or lower the cot with the side release
handle.
•
Always remove your foot from the base tube when you are lowering the cot to the lowest position.
•
Always use Power-LOAD with the 6085/6086 Performance-PRO XT, 6500/6506 Power-PRO XT, and 6510/6516
Power-PRO IT cots with the Power-LOAD option only. In certain situations, you can use Power-LOAD as a standard
antler for most X-frame cots, but a rail clamp assembly is required for all cots without the Power-LOAD option.
•
Always make sure that you use a Power-LOAD date of manufacture cot with the Stryker Model 6390 Power-LOAD
system to avoid the risk of injury.
•
Always support the load of the patient, cot, and accessories after the weight is off of the ground.
•
Always lock the undercarriage before you remove the loading wheels from the vehicle patient compartment floor.
An unlocked undercarriage will not support the cot and injury to the patient or operator could result.
•
Always lock the head section into place before you operate the cot.
•
Do not load the cot into a vehicle with the head section retracted when using a cot fastener. The cot may tip or not
connect with the cot fastener.
•
Do not install or apply a wheel lock on a product with worn wheels that are less than 6 in. diameter.
•
Always use two people when using the kickstand.
•
Always center the patient weight on the cot before you use the kickstand.
•
Always apply the kickstand with your foot only.
•
Always lower the cot height before you apply the kickstand for increased stability.
•
Do not apply the kickstand during transport. Keep the kickstand in the retracted position.
•
Do not use the kickstand as a brake.
•
Do not apply the kickstand on a sloped surface.
•
Always use all restraint straps to secure the patient on the cot. An unrestrained patient may fall from the cot.
•
Do not attach restraint straps to the base tubes or cross tubes.
•
Always use all restraint straps to secure the patient on the cot. An unrestrained patient may fall from the cot.
•
Do not attach restraint straps to the base tubes or cross tubes.
1-4
Summary of safety precautions
6086-209-005 REV G
www.stryker.com
Quicklinks ausblenden:
Werbung
Kapitel
