Installing The Optional Base Storage Net; Installing The Backrest Storage Pouch - Stryker Performance-PRO XT Bedienungsanleitung

English
Attaching an oxygen bottle to the retractable head section oxygen bottle holder
EN
(Continued)
Notes
• The optional fowler oxygen bottle holder (6500-241-000) is not compatible with the optional retractable head
section oxygen bottle holder (6085-046-000).
• Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always
place the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
• Inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.

Installing the optional base storage net

CAUTION
• Do not load the base storage net above the safe working load of 20 lb (9 kg).
• Always be careful when you retract the base to avoid damaging items that are stored in the base storage net.
To install the base storage net, wrap the Velcro® straps around the base tubes.

Installing the backrest storage pouch

CAUTION
• Do not load the backrest storage pouch above the safe working load of 20 lb (9 kg).
• Do not allow the storage pouch to interfere with the operation of the retractable head section.
To install the backrest storage pouch
1. Insert each strap through a hole in the backrest skin.
2. Mount the pouch flat against the backrest.
3. Secure the backrest storage pouch to the cot with the Velcro straps.
1-44
Operation
B
A
Figure 1-34: Oxygen bottle attachment
(Figure 1-35 on page
6086-209-005 REV G
1-45):
www.stryker.com