Status and Error Message
Unscrew the cover caps of the individual chambers using a large screwdriver to see
the battery's liquid level on the acid level markings. If the liquid is below this measure,
top up with distilled water.
Maintenance-free lead gel batteries can be used as an option.
10.10 Fuse
The 80 A fuse is located at the rear end of the battery case (fig. 24).
11
Status and Error Analysis
The MCS control has different indication categories for the status and error analysis.
Depending on the effects on the system, the control differentiates the following
indications:
In the following tables, the indication codes with the corresponding error groups as
well as the possible causes and measures are described.
76
Note!
When checking the battery's filling level of the B600 power
wheelchair, make sure the B600 is standing on level ground!
Attention!
During any maintenance work on the B600 where the battery
cover is open, the fuse must always be removed for safety
reasons.
Fig. 24:
Fuse holder
Warning
Error
Defect
Failure
B600 – Instructions for Use