Switching On - Otto Bock B 600 Bedienungsanleitung

10.1

Switching On

Press button 1 to switch on the wheelchair control (fig. 14).
The indicator 4 shows the remaining battery capacity.
The indicator 10 will show 1-4 lit LEDs depending on the selected speed level. When
the battery indicator flashes or the LEDs continually light up one after another, this
means a system error has occurred.
When the control unit is not used for some time, the wheelchair is switched off
automatically. The control can be switched off at any time using button 1; if this occurs
whilst driving the wheelchair will be braked immediately.
B600 – Instructions for Use
Note!
Upon delivery, the main fuse of the B600 power wheelchair is
not connected. It is contained in the protective covering on
the control panel. Before using the B600 power wheelchair,
this fuse must be inserted into the fuse holder at the rear end
of the battery case (see section "Putting into Operation /
Fuse").
1 2
10
9
8 7
Fig. 14: Control panel
Item
1
2
3
4
5
6
7
8
9
10
3 4
6
Description
On/Off
Horn
Light
Battery indicator
Joystick
Direction indicators, right and left
Warning flasher
Indicator "Drive or additional function"
Increase speed level / Additional function
Speed level indicator
Putting into Operation
5
67