Telecom Behnke 10 series Kurzanleitung Seite 44

LIFT EMERGENCY TELEPHONES
4 Configuration
Use internal configuration keyboard (open universal casing for this purpose).
∗
1 2 3 4 5
∗
Alternatively, configuration can also be done by DTMF telephone (touch-tone telephone).
#
Configuration is only possible with the a/b line (telephone line) connected.
6 7 8 9 0 #
T
E
L
Entry (code / parameter)
(factory setting)
n 0 0 0 0
A button from
0 4 0
A button from
0 6 0
A button from
0 7 0
1 0 Number (4-digits max.), then
2 0 A button from 0
Phone number to be dialled, then
2 1
Phone number to be dialled, then
2 2
Phone number to be dialled, then
2 3
Phone number to be dialled, then
2 4
Phone number to be dialled, then
2 5
Phone number to be dialled, then
2 6
Phone number to be dialled, then
2 7
Phone number to be dialled, then
2 8
Phone number to be dialled, then
2 9
= not allowed, then
9 0 0 0
= allowed, then
1
= as a make contact, then
0
9 7 0
= as a break contact, then
1
n
Following the entry of each phone number and other configuration steps, do not forget to press the
In each case, finish configuration mode with
For further configuration steps (relay control, sound settings, voice-announcement/real-time clock extension electron-
ics), please refer to our comprehensive technical manual (available as PDF on the Internet – see also note on page 2).
18
Function
Enable configuration mode
to , then Direct-Call Button Response Delay
9 #
0 = none, 1 = 1 second, 9 = 9 seconds
to , then Volume; 0 = low, 9 = high (full-duplex mode)
9
#
to , then Volume; 0 = low, 9 = high (with add-on amplifier)
9 #
Note: Preferably use values between 1 and 4.
1st code for controlling relay 1
#
to 9 , then Group Call / Redial / Undroppable Call:
#
Number of phone numbers to be dialled
1st phone number in case of redial or:
#
– in the case of 20-0018: phone number of the
button connected to the T1 contact (microphone and
LS in the telphone active).
– in the case of 20-0028: phone number of the emergency button
on the telephone for initiation on top of the car (integrated MLM).
Phone number for MLM A (yellow jack) = inside the car or button
#
connected to T2 contact or 2nd phone number in case of redial
Phone number for MLM B (blue jack) = on top of the car (not in
#
the case of 20-0028, because MLM is integrated on top of the car!)
or 3rd phone number in case of redial
Phone number for MLM C (red jack) = underneath the car or
#
4th phone number in case of redial
5th phone number in case of redial
#
6th phone number in case of redial
#
7th phone number in case of redial
#
8th phone number in case of redial
#
9th phone number in case of redial
#
or phone number for
Only when configuration is allowed can the
#
following configuration step be performed
#
T2 operational mode
#
T2 operational mode
#
End configuration mode
. Otherwise it is possible that your entry is not stored correctly!!
n
button of the dial pad
Standard setting
0
5
0
0
0
—
—
—
—
—
—
—
—
—
—
0
0
0
0
button!
#