Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S E R I E S 1 0 / S E R I E S 2 0
3
Configuration
Use internal configuration keyboard (after removing the cover from the electronics casing).
∗
1
2
3
4
5
∗
Alternatively, configuration can also be done by DTMF telephone (touch-tone telephone).
#
Configuration is only possible with the a/b line (telephone line) connected.
6
7
8
9
0
#
T
E
L
Entry (code / parameter)
(factory setting)
n
0 0 0 0
A button from
0 6
0
A button from
0 7
0
Number (4-digits max.), then
1 0
Phone number to be dialled, then
2 1
Phone number to be dialled, then
2 2
Phone number to be dialled, then
2 3
:
:
Phone number to be dialled, then
2 8
Phone number to be dialled, then
2 9
n
Following the entry of each phone number and other configuration steps, do not forget to press the
In each case, finish configuration mode with
For further configuration steps (relay control, sound settings, voice-announcement/real-time clock extension electron-
ics), please refer to our comprehensive technical manual (available as PDF on the Internet – see also note on page 2).
Mounting / Installation
4
4.1 Series 10 / Home Office:
Faceplate
6
Function
Enable configuration mode
to
, then
Volume; 0 = low, 9 = high (full-duplex mode)
9
#
to
, then
Volume; 0 = low, 9 = high (with add-on amplifier)
9
#
Note: Preferably use values between 1 and 4.
Door-opener code (= 1st code for controlling relay 1)
#
Phone number for 1 button
#
Phone number for 2 button
#
Phone number for 3 button (only Series 20)
#
:
Phone number for 8 button (only Series 20)
#
Phone number for
#
End configuration mode
. Otherwise it is possible that your entry is not stored correctly!
n
Telephone a/b
To door opener
Electronics
package
button on the dial pad (only Series 20)
Surface-mounted
frame 10-5100
(accessory)
Insert gasket!
Standard setting
button!
#
Flush-mounted
casing 10-5200
(accessory)
Insert gasket!
5
0
0
—
—
—
—
—
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
