Care And Cleaning - Gastroback DESIGN BROTBACKAUTOMAT ADVANCED Bedienungsanleitung

Problem
The time flashes on the
LCD screen. The appli-
ance does not respond
to your input.
Unusual information is shown on the screen.
H:HH (after starting the
program)
E:E0 (after starting the
program)

CARE AND CLEANING

WARNING: Always ensure that the appliance is out of reach of young
children.
Always switch OFF the appliance (holding the START/STOP button touched until a
beep sounds), then unplug the appliance, and wait until the appliance cooled down
(at least 20 minutes), before moving or cleaning the appliance. Do not attempt to
move the appliance during operation.
The surfaces of the bread pan and kneading paddle have a non-stick coating. Do not
scratch or cut on the non-stick coatings. Do not use any abrasive cleaners or corro-
sive chemicals (e.g. bleach, oven cleaner or grill cleaner) for cleaning the appliance
or any parts of it, to avoid damage to the surfaces. Do not use any hard or sharp-
edged objects for cleaning any surfaces of the appliance.
Ensure to protect the housing against splashing water and moisture. Do not immerse
the housing, or power cord in water or any other liquid, to avoid hazards due to
electric shock and damage. Do not spill or drip any liquids on the housing or power
cord, or in the heating compartment to avoid risk of fire and electric shock. Do not
use violence!
Do not clean the appliance or any part or accessories of the appliance in
an automatic dishwasher.
1. Unplug the appliance and with the lid open, leave the appliance cool down to
room temperature (at least 20 minutes).
Possible Reason
The running program is
paused.
The appliance is in time-
setting mode.
The temperature within
the heating compartment
is too high.
The temperature probe
failed.
The Solution
Touch the START/STOP button to continue operation. Alter-
natively, after approx. 3 minutes the appliance re-assumes
operation automatically.
With some programs (11, 13, 15, and 16) you can set the
processing time using the +TIME and -TIME buttons, indica-
ted via flashing time. Set the desired time, then shortly press
START/STOP to confirm. See: "Programs of the Bread Maker".
Immediately touch the START/STOP button to stop the pro-
gram, and unplug the appliance. Then open the lid and let
the Bread Maker cool down completely before using it again.
Send the appliance to an authorized service centre for repair.
107