Danfoss TripleLynx Installationshandbuch Seite 19

3. Start-up and Check of Settings
3
Illustration 3.3: Set date
Illustration 3.4: Select country
Illustration 3.5: Confirm country selection
Note:
If the two country selections do not match they will be cancelled and it will be necessary to
redo the selections. If a wrong country is accidentally accepted at the first selection, simply
accept the "Country: Undefined" in the confirm country screen. This will cancel the country
selection and a new selection is possible. If a wrong country is selected twice, please call serv-
ice. Alternatively, the selection can be changed by accessing the Setup Details menu under
[ Setup → Setup Details]. This requires security level 2 or higher.
The inverter will start automatically if sufficient solar radiation is available. The start-up will take
a few minutes. During this period, the inverter will carry out a self-test.
18
The inverter only complies with local and national standards provided the correct
country has been selected. If a different country than the one the inverter is installed
in is chosen it can have serious consequences.
Set date as prompted by the display. Press
'OK' to select. Press '
▲
the numbers. Select by pressing 'OK'.
The display will now show "Select country".
The country is set to "undefined" at initial
start-up. To select country press 'OK'. Press '
' to scroll down through the list of countries.
▼
Select the country in which the inverter is in-
stalled by pressing 'OK'. It is very important
that the correct country is chosen.
Confirm your choice by selecting the country
again and press 'OK'. The settings for the
chosen country have now been activated.
L00410309-03_2q
' to scroll up through