Glossary (Description Of The Most Important Operating Elements) - Nussbaum WA 970 Betriebsanleitung

In order to carry out adjustments at the front or rear axle, push the
buttons , and possibly
The values of camber and caster will only be shown,
when each half- toe is adjusted to a value of 0°.
Having finished all adjustments, the measuring values of the new
adjustments have to be recorded.
The recording of the final values is performed analog to the
recording of the previous values.
Finally you receive a data sheet, which contents as well the target
values as the recorded measuring values (previous and final
values).
Data sheet with pervious and final values
By pushing the button
about the customer, the car or the process. These information are
shown afterwards as headline of the data sheet.
In the menu bar of the data sheet screen you can choose between
further possibilities: Either you can print the data sheet
you save it or you combine both possibilities
Both the recording of the final values and the end of the session
are further possibilities for your procedure.
1 689 979 873N 19.03.2010
.
you can fill in different information
12. Glossary (Description of the most im-
portant operating elements)
12.1 Main menu
Starting the vehicle wheel alignment procedure
Configuration and maintenance
Access to the utility function for the configuration and
maintenance of the wheel alignment device
Utility programs
Access to the functions for the service and diagnostics
of the wheel alignment device
Switching off
Shuts down the PC and then powers it off.
Help
Display of information on the current screen.
The online instructions are a supplement, but not an
equivalent replacement for the manual for usage and
maintenance.
Maximum steering deflection
Calling the steering deflection for determining the
maximum steering deflection.
Steering deflection
Calling the steering deflection for the measurement of
the caster, S.A.I., the steering angle difference at 20°.
Data overview
Calling the vehicle data overview
Front axle
Calling the front axle setting
Rear axle
Calling the rear axle setting
Data overview and printing
Calling the step Data overview and printing the process
or
End of work
. Ends the ongoing process and returns to the main
menu
12.2 General functions
Continue
Continue to the next program step of the previously
defined sequence
Previous step
Return to the previous program step
91