Checking The Range Of The Remote Control Transmitter - Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung

4 P
REPARATION
- Carefully connect both red plugs.
- Place the battery support with the
cables and the plug in the battery
box again.
- Close battery box, without
clamping the cables.
- Insert the lower end of the
antenna guiding tube in the
opening on the receiver box.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
- Carefully close the receiver box.
- Make sure that the latch is
properly locked in place.
4.6
C
HECKING THE RANGE OF THE REMOTE CONTROL TRANSMITTER
In order not to lose control over you model, you should, before each first start or after a crash, check the function
and the range of the RC system.
For the range test, it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
- Pull out the antenna of the transmitter completely and switch the transmitter on then the receiver.
- Stride away from the model, approx. 50 m (engine does not run).
- Place the right lever of the remote control and the corresponding trim lever in neutral position
- Move the steering wheel (channel 1) towards the right.
Now the wheels must drive in towards the right!
- Move the steering wheel towards the left.
Now the wheels must drive in towards the left!
- Release the lever of the remote control,
the wheels must turn back into the straight drive position.
Never drive the model with a remote control that is not functioning properly!
In the best case, "only" the model will suffer damages.
If the remote control does not function perfectly, check the charge state of the transmitter first, and
the rechargeable batteries of the receiver, then make sure that no other person is operating a vehicle on your frequency.
If the problem still persists, consult the trouble shooting table.
© REELY 09/07
- Open receiver box and carefully
remove the receiver
- Unwind the wire of the antenna
and guide it outwards through the
opening in the cover of the
receiver box.
Also make sure that the cover can
still be opened easily after fix-
ing the antenna wire to enable a
change of the rechargeable
batteries.
- Switch the transmitter on.
The green LED lights up.
If the LED does not light up, check
rechargeable batteries and replace
them, if necessary.
- Guide the antenna of the receiver
through the antenna guiding tube
- and guide it out at the other end.
- Switch on the receiver with the
switch on the chassis.
The servos must turn in neutral
position.
NOTE!
Switching on:
1. Transmitter, 2. Receiver
Switching off:
1. Receiver, 2. Transmitter
47