Checking Alignment And Tooth Backlash Of Drive; Putting The Rc System Into Operation - Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung

4 P
4.4
C
HECK ALIGNMENT AND TOOTH BACKLASH OF DRIVE
The engine transmits its capacity via the pinions on the clutch bell to the main pinion at the center differential.
Both rotary axes, i.e. the crank shaft, engine-sided, and the axis of the drive section to the front and rear axis, must be
aligned so that they are exactly in parallel. This prevents tensions in the drive section, premature wear of the pinions and
bearing journals as well as loss of power.
The parallel alignment of crankshaft and drive section must be checked every time before using the vehicle
and, if necessary, must be readjusted!
When the alignment is in parallel, the pinion on the clutch bell and the main pinion will run smoothly.
If there is too much play, this will destroy the toothed wheels in the long run; too little play destroys the bearing in clutch
and engine.
Checking the tooth backlash
- Place thin strips of paper between the pinions on the
clutch bell and the main pinions in the drive section.
- Move toothed wheels by hand;
the paper strips must not rip apart when the wheels
turn!
Readjusting
- Unscrew four screws of the engine mount fastener on the
lower side of the the mounting plate (chassis)
- Align engine laterally and fasten screws again tightly
- Unscrew four screws, at the top, on the engine support
and adjust the engine vertically
4.5
S
TARTING THE
Take note of the separate operating manual of the Remote control!
- Remove lid of battery compart-
ment on the lower side of the
transmitter.
- Insert 8 AA (rechargeable) batte-
ries in the compartment,
observe the correct polarity!
- Close the lid again
46
REPARATION
RC I
NSTALLATION
-
-
Open battery box on the chassis
and
remove the battery support
of the battery box.
Operating Instructions 4WD Chassis Hunter / Streethunter 4.1 Item No. 23 47 46 / 23 47 64
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.