Checking The Range Of The Remote Control Transmitter; G) Check Carburettor Basic Settings - Reely RAMBO Racing 7.5 RTR Bedienungsanleitung

4. Preparation
- Guide the antenna of the receiver through the antenna guiding tube
- Stick the lower end of the antenna guiding tube into the recess on the cover of the RC box.
- Fasten the antenna wire on the top at the guidance tube, by wrapping adhesive tape around it or by
placing a rubber cap.
Do not shorten the antenna!
- Switch the transmitter on.
The Control LED of the transmitter should light up.
If the LED does not light up, check batteries /rechargeable batteries and replace
them, if necessary.
- Switch on the receiver with the switch on the RC-box.
The servos must turn in neutral position.
Always switch ON the transmitter first then the receiver.
First switch OFF the receiver, then the transmitter.
f)

Checking the range of the remote control transmitter

In order not to lose control over you model, you should, before each first start or after a crash, check the function and the range
of the RC system. For the range test, it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
Because of the good adhesion of the tires and because of the weight of the vehicle, in the stand and on the ground, the wheels will not follow your
steering spontaneously and directly. This however changes during operation.
- Pull out the antenna of the transmitter completely and switch the transmitter on then the receiver.
- Stride away from the model, approx. 50 m (engine does not run).
- Place the right lever of the remote control and the corresponding trim lever in neutral position
- Move the steering wheel (channel 1) towards the right. Now the wheels must drive in towards the right!
- Move the steering wheel towards the left. Now the wheels must drive in towards the left!
- Release the lever of the remote control, the wheels must turn back into the straight drive position.
Never drive the model with a remote control that is not functioning properly!
In the best case, "only" the model will suffer damages.
If the remote control does not function perfectly, check the charge state of the transmitter first, and the rechargeable batteries of the receiver, then
make sure that no other person is operating a vehicle on your frequency.
If the problem still persists, consult the trouble shooting table.
g) Check carburettor basic settings
Fine tuning of idle speed and full throttle can only be carried out
with a well run in engine
The carburettor of Buggy "RAMBO Racing 7,5" is characterized by a material
combination of a new type made of plastic and metal.
The low thermal absorption of the synthetic material, compared to a carburettor
made of metal only, reduces the evaporation of the fuel mixture already in the
carburettor.
Thus, the fuel supply can be more precise, even with a hot engine and can be
regulated in a simpler way.
46
Main nozzle
needle
Throttle stop screw
Operating Instructions 4WD GP BUGGY RAMBO RACING 7,54 RtR No. 3 51 85
Air suction opening
Idle speed mix- adju-
sting screw