Three-Channel Remote Control 40 Mhz Fm - Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung

3 D
ESCRIPTION OF THE MODEL
3.1
T
HREE -CHANNEL
Take note of the separate operating manual of the Remote control!
Three-channel remote control transmitter
Pistol transmitter with steering wheel for steering and pull for the speed as well as a switch, which serves to shift a third
servo to up to five different positions.
Antenna
Transmitter antenna: Emits the signals of the remote control transmitter as radio signals.
Receiver antenna: A simple wire on the receiver in the vehicle, whose length is exactly tuned to the transmission frequency
of the remote control system with which the control signals are optimally received.
Channel button (CH):
With this button, you select the submenus of the menu items in the settings menu in which the settings are to be made.
Channel 3
Several servo positions can be pre-programmed for channel 3.
Charging socket
The ON/OFF switch must be in the "OFF" position before you start charging!
NOTE! Never try to charge dry cell batteries.
Dual rate steering deflection DT3
The deflection of the steering servo can be adjusted with the settings button in a range from 0% to 100%. This setting has
the same effect on both steering directions (to the left and the right). The higher the value in percent, the more sensitive the
steering reacts to the control signals.
Dual rate brake lever deflection DT4
For the throttle/brake servo, the dual rate setting on the button DT4 can only be set for the brake path, not for the throttle
function.
EPA (End Point Adjustment)
Selective limitation of the servo stops for both directions and for all 3 channels.
For the channels 1 and 2, this function can be adjusted in a range from 100% - 120% and for channel 3 in a range from
0% - 120%.
© REELY 09/07
R
EMOTE CONTROL
1. Telescopic antenna
2. Settings button DT 2
3. SEL button
4. Settings button plus (+) and minus (-)
5. CH button
6. Steering wheel for the steering function
7. Lever for the drive function
8. Operating button for channel 3
9. Control LED
10. Settings button DT 4
11. Charging socket
12. Settings button DT 3
13. Function switch
14. LC display
15. Settings button DT 1
39