Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung Seite 57

6 S
ET
M
OUNTING THE STEERING SERVO
The steering of "Hunter / Streethunter 4.1" is designed as axle
leg steering.
At the same time, the steering knuckle arms are connected with a
three-part steering link. The pivoting movement of the servo cont-
rol lever has an impact on the steering linkage and on one arm of
the servo saver.
The servo saver consists of two right-angled levers, which can
be moved against each other against a spring in one level with
the servo steering lever. The second lever arm of the servo saver
steers the center part of the steering link, hence causing the
wheels to turn. (an impact on the wheels has a reverse effect via
the steering knuckle arm on the steering link and the second arm
of the servo saver, prevents the flexible connection to the first
lever arm of the servo saver, that this impact is immediately gui-
ded into the servo, thus damaging the latter.)
Turning right and left is limited by a mechanical stop of the stee-
ring knuckle arm against the axle leg support.
The effect of the servo saver can be adjusted with a knurled nut (6) by modifying the contact pressure on the
two lever arms.
Turning right and left is limited by a mechanical stop of the steering knuckle arm against the axle leg support.
I
NSTALLATION OF THE STEERING SERVO
- Point the wheels in driving direction "straight".
- Place the servo shaft via the remote control transmitter in
the neutral position.
- Push the steering servo (servo shaft towards the front) in
the attachments on the chassis of the RC mounting plate
and
- screw the steering servo with the plastic counter-pieces of
the servo
fastening set (underneath the RC mounting plate).
- Place the servo control lever vertically on the servo shaft in
order to establish a connection as straight as possible with
the arm of the servo saver without modifying the position of
the wheels.
- Screw the steering linkage at the servo control lever and
on the arm of the servo saver
Function control:
- Support the model at the front in a way that allows the wheels to hang freely.
Because of the good adhesion of the tires and because of the weight of the vehicle, in the stand and
on the ground, the wheels will not follow your steering spontaneously and directly.
This however changes during operation.
- First, switch on the transmitter, then the receiver.
- Move the steering wheel (channel 1) towards the right and the left.
Now the wheels must drive in towards the right and the left!
If the wheels turn in opposite direction, change the Servo Reverse on the remote control to position "REV"
(Reverse).
- Release the steering wheel; now the wheels must turn in straight line again.
- If the wheels do not stand straight when the steering wheel of the remote control is in neutral position, correct
the position by adjusting the trim on channel 1.
The steering wheel limit stops must limit the right / left limit stops of the steering!
© REELY 09/07
-U
P
57