Setting The Alignment; Rc-System ( In Replacement , Optional ) - Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung

6 S
Fine tuning of inclination on front and rear wheels
- Twist clamping screw in the upper transverse link
clockwise:
The upper edge of the wheel is pulled inward in direction
"negative inclination".
- Twist clamping screw in the upper transverse link
anticlockwise:
The upper edge of the wheel is pulled outward in direction
"positive inclination".
Ensure a balanced tuning of the cornering power of
front and rear axles as differences can result in an
over-steering or an under-steering driving behavior.
6.4
S
ETTING THE ALIGNMENT
The alignment designates the position of the wheel level to the driving direction.
During the drive the tires are pushed apart in the front because of the rolling friction and this is why they are no longer
exactly parallel to the drive direction. To balance, the wheels of the stationary vehicle can be set, so that they point slightly
inward.
This toe-in effects an improved lateral cornering of the tire and therefore a more direct response of the steering If a milder
response of steering is desired, this can be achieved accordingly by adjusting a toe-out , i.e. the wheels of the stationary
vehicle point outward.
For a rough adjustment of the alignment, the outer steering links
can be screwed on the middle steering link part at two further
fastening points.
The clamping screws with spanner flat (5mm) for the separate
adjustment of the inclination of the front wheel are located in the
right and left steering link.
The toe-in of the front wheel must not exceed 4°.
Toe-in
Setting a toe-in makes the
inner part of the tires wear faster.
�����������
6.5
I
NSTALLATION OF AN
The standard Hunter / Streethunter 4.1 is equipped with built-in RC system, receiver, steering servo and
throttle/brake servo. It is also equipped with a remote control transmitter. This top quality system allows you
to operate your model without any problem.
You might find the following installation instructions interesting if you already have an RC system and if you
wish to built-in the latter or if you must replace a defective component.
56
-U
ET P
RC-S
������������
(
YSTEM IN REPLACEMENT
Operating Instructions 4WD Chassis Hunter / Streethunter 4.1 Item No. 23 47 46 / 23 47 64
(a)
Toe-out
Setting a toe-out makes the
outer part of the tires wear faster.
, )
OPTIONAL