Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung Seite 40

3 D
ESCRIPTION OF THE MODEL
LED display
Indicates the on-position of the transmitter.
Select button (SEL):
To access the setting menu, the transmitter must be switched on while keeping the SEL button depressed.
The individual software functions can also be called up with this button in a programming menu.
Setting buttons „+"/"-"
For setting the changes in the submenus in the programming function
Setting button DT1/DT2
Setting of the steering servo trimming (DT1) or the throttle/brake servo (DT2) in steps of +1% (to the right) or -1% (to the
left). . Other functions can be assigned to the setting buttons DT1 - DT4 in the settings menu.
Setting button DT3/DT4
For setting the dual rate values for the steering (DT3) and the brake path (DT4). Other functions can be assigned to the
setting buttons DT1 - DT4 in the settings menu.
Steering wheel
The steering wheel is turned in the desired driving direction towards the right and the left.
Transmitter/receiver crystal
Transmitter and receiver crystal are available separately and can be exchanged.
Transmitter crystal: Frequency provider of the transmitter.
Receiver crystal: A crystal, which is perfectly attuned to the receiver (on the chassis), is attached in the receiver.
Both crystals have to be exchanged for a frequency change!
Trimming
Fine adjustment of the servo neutral position of the steering servo (DT1) or the throttle/brake servo (DT2). The dual rate
values should be set to 100% for this purpose. With maximum control path for the steering/throttle/brake lever deflection, the
fine adjustment is facilitated.Gas/Bremshebel
Der Gas/Bremshebel wird zum Bremsen nach vorne und zum Beschleunigen nach hinten bewegt.
40
Operating Instructions 4WD Chassis Hunter / Streethunter 4.1 Item No. 23 47 46 / 23 47 64