Maintenance / Disposal - Reely 4WD GP STREETHUNTER 4.1 Bedienungsanleitung

7 M
T S
RANSVERSE TABILISERS
To reduce body roll (curl) of the vehicle when going through bends, the model
is equipped with a transverse stabiliser at the rear; the vehicle can be retrofit-
ted with a transverse stabiliser at the front.
A transverse stabiliser is made of a u-shaped curved spring steel wire, which is
at both ends connected with one of the lower transverse arms via ball-shaped
heads. For this reason, two steering points for the ball-shaped heads are pro-
vided (a). In the centre, the wire bracket is mounted to rotate on the differential
housing. The boreholes for the mounting are also provided (b). When one wheel
is deflected, the other wheel is then also deflected via the bracket. The trans-
verse stabiliser also supports the effect of the oil-dampened shock absorber
when the wheel is rebounding, since the restoring force of the wire bracket sup-
ports the rebounding of the shock absorber (against the friction in the piston).
In this way, the wheel remains in contact with the ground in every situation.
A E
CKERMANN FFECT
To adjust the progressivity of the steering angle or the Ackermann effect, the
steering links can be reset to other steering points both in the steering arms and
in the steering plate.
D
AMPING
To further optimize the damper characteristics, we offer, in our accessories, silicon oil for the shock absorbers in different
viscosities!
Our product range also includes tuning springs of various hardness.
7 M
At certain intervals, maintenance work and function controls that ensure trouble-free operation and road-
worthiness for a long time, must be carried out.
Engine vibrations and shocks during drive operation can loosen parts and screw connections.
Therefore, check before each use:
- The tight position of wheel nuts and of all screw fittings;
when replacing screws, secure the latter with screw-lock-laquer
- the secure position of the servo control lever on the servo shaft
- the position and the state of fuel hoses and air filter
- the laying of cables
Also check the charging state of the rechargeable batteries of the transmitter and the receiver
C
LEANING
- After driving, clean the entire vehicle of dust and dirt, use compressed air and / or a special spray detergent.
Pay particular attention to the bearings. Occasionally, remove the wheels and clean the ball bearing from dust
and deposits.
After cleaning, the movable parts must be re-lubricated.
After having lubricated the bearings remove any leaking oil and grease, since this is where dust can settle
particularly well.
- Clean the cooling fins of the cooling head regularly with a toothbrush, in order to ensure an optimal heat
dissipation.
60
/ D
AINTENANCE
AINTENANCE
Operating Instructions 4WD Chassis Hunter / Streethunter 4.1 Item No. 23 47 46 / 23 47 64
ISPOSAL