Herunterladen Inhalt Inhalt Diese Seite drucken

Reely McFlash RTR Bedienungsanleitung Seite 43

2wd gp stadium buggy 1:10
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Carburettor linkage
A visual check of the carburettor outlet is possible after removing or before attaching the air filter.
-
Idle speed position (max. 1 mm open carburettor outlet), if necessary, readjust the
adjusting screw at the idle speed (choke limit stop screw).
The idle speed adjusting screw is the little screw on the opposite side of
the carburettor slide.
The throttle / brake linkages have the following impact:
Full throttle: Carburettor slide fully pulled out, brake has no impact
Idle speed: Carburettor slide fully in, adjusting rings are loose on the brake levers.
Brakes:
Throttle linkage presses against spring resistance, brake linkages press forward against the fully
deflected brake lever.
Function control of the throttle/brake servo
-
Move the lever of the remote control (channel 2) towards the back (full throttle position).
The slide carburettor must now be completely pulled out, the carburettor outlet opened to its maximum.
The brakes have no impact.
If the slide carburettor does not start up when you actuate the remote control, set the Servo Reverse for
channel 2 to "REV" in order to reverse the direction of rotation of the servo.
If the slide carburettor does not start up fully, correct the servo travel at the rocker switch (channel 2) of the remote
control transmitter
-
Release the lever of the remote control.
Now the slide carburettor must go back to the idle speed position (carburettor outlet opened to approx. 1 mm).
The brake still has no impact.
-
Press the lever of the remote control forward as far as it will go (braking)
The slide carburettor must remain in the idle speed position (carburettor outlet opened to approx. 1 mm).
The servo lever at the carburettor linkage pulls against a spring resistance, the servo lever at the
brake linkage actuates the brake lever.
-
Release the lever of the remote control again; now the brakes should be released again.
You can adjust the brake linkage by moving the adjustment rings at the brake steering levers accordingly.
© REELY 07/07
43

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Streetracer pro rtr

Inhaltsverzeichnis