Receiver Battery - Reely McFlash RTR Bedienungsanleitung

2wd gp stadium buggy 1:10

Inhaltsverzeichnis

Verfügbare Sprachen

ESCRIPTION OF THE MODEL

Differential

Differential gear. Equalizes the different revolution speeds, e.g. between the wheel on the inside of a bend and the outside of

a bend.

Fuel tank

The fuel tank with snap closing contains 580 ccm and is equipped with an integrated fuel filter. The tank is connected with

the carburettor by means of two hoses at the fittings in the cover via a manual pump. A further hose is used for fuel-tank

venting.

Inclination

Inclination of the wheels as viewed from the front:

Main nozzle needle

Regulates the fuel supply to the carburettor in middle to full load range

Oil pressure shock absorbers

The shock absorber consists of a coil spring with a piston in an oil-filled cylinder running up and down at the center. The

coil spring is supported by a spring seat at the end of the piston rod and, depending on the design, a ring bolt or a spring

pretensioner on the outer side of the cylinder. The spring pretension can be adjusted infinitely at the ring bolt or can

be adjusted stepwise via spring pretensioners of different sizes. The spring absorbs the travel of the axle halves when

traveling in uneven terrain. The bounding and rebounding is dampened by the piston moving through the oil. By selecting

different dampening oils the dampening properties can be varied. The shock absorber is mounted between the shock tower

at the top and the lower transverse link. The compression distance is limited via a plastic sleeve.

Depending on the model, the spring pretension can be adjusted infinitely at ring bolts or can be adjusted stepwise via

spring pretensioners of different sizes.

Operating Sequence of the control:

Driver

Transmitter

RC model

"Radio controlled", to be more precise: "Remote Controlled" Model

Receiver

Receives and "translates" the control signals of the remote control transmitter (direction and intensity) for the servo and the

cruise control. The transmitter crystal which is tuned to the receiver crystal ensures the perfect communication between

transmitter and receiver. Transmitter and receiver crystals are thus tuned to one another, so that signals of parallel transmit-

ters cannot disturb this receiver (this model).

Resonance exhaust silencer

The resonance exhaust silencer serves, on the one side, to absorb sounds, on the other side, to display the optimal output

of the engine.

Roll center

The roll center ist he theoretical point, over which the axle of a vehicle tilts in a curve. The imagined connection of the roll

centers of the front and rear axles is called roll axle and is ideally located vertically underneath the center of gravity. When

the roll center is low, the leverage effect of the center of gravity is high, the vehicle tends to bend and dislocate in corners

around the roll axle. A high roll center decreases the lateral inclination.

Servo lever (servo arm)

Lever, disk or cross with 4 control levers which transmit the rotational movement of the servo

motor via steering levers.

Positive inclination

Steering servo

Receiver

Throttle/Brake servo