Putting The Rc System Into Operation - Reely McFlash RTR Bedienungsanleitung

4 P
REPARATION
4.4
S
TARTING THE
- Remove lid of battery compart-
ment on the lower side of the
transmitter.
- Insert 8 AA (rechargeable) batte-
ries in the compartment,
observe the correct polarity!
- Close the lid again
- Carefully connect both red plugs.
- Place the battery support with the
cables and the plug in the battery
box again.
- Close battery box, without
clamping the cables.
- Insert the lower end of the
antenna guiding tube in the
opening on the receiver box.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
- Carefully close the receiver box.
- Make sure that the latch is
properly locked in place.
© REELY 07/07
RC I
NSTALLATION
- Open battery box on the chassis
and
- remove the battery support
of the battery box.
- Open receiver box and carefully
remove the receiver
- Unwind the wire of the antenna
and guide it outwards through the
opening in the cover of the
receiver box.
- Switch the transmitter on.
The green LED lights up.
If the LED does not light up, check
rechargeable batteries and replace
them, if necessary.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.
- Guide the antenna of the receiver
through the antenna guiding tube
- and guide it out at the other end.
- Switch on the receiver with the
switch on the chassis.
The servos must turn in neutral
position.
NOTE!
Switching on:
1. Transmitter, 2. Receiver
Switching off:
1. Receiver, 2. Transmitter
41