Inserting Hosepack Components Into The Hosepack - Fronius Robacta Drive CMT Serviceanleitung

Inserting hose-
pack components
into the hosepack
(continued)
Hosepack components on CMT pull-in tool,
arrangement of hosepack components
Pull-in hosepack components
Pull the LHSB cable for the length of the motor lead
(4)
(3)
(2)
(1)
(11) (4)
(12)
(14)(15)
9.
(5)
(6)
10. Push the right-hand kink protector
11. Push the M42 x 1.75 hose nut (13)
12. Lubricate CMT pull-in rod and pull-in
13. Pull shaft protection hose (12) over
(13)
14. Push the M42 x 1.75 hose nut (13)
Important! In the case of hosepacks
longer than approx. 4 m, the pull-in pro-
cess will require 2 people.
Important! Take care not to cross the
hoses when pulling in the hosepack. Keep
the individual components in their positi-
ons.
15. Pull the shaft protection hose (12)
16. Remove adhesive tape from motor
17. Pull the LHSB cable (14) the same
18. Remove the remaining adhesive tape
19. Unscrew the current/water cable from
32
Pass the remaining hosepack compo-
nents through the right-hand kink
protector and attach to the CMT pull-
in tool with adhesive tape according to
the illustration
(1) Current/water cable
(2) Water hose for water return
(3) Motor lead
(4) LHSB cable
(5) Gas hose
(6) Air hose
(11) up to the central connection (4)
towards the central connection
tool with soft soap
the pull-in rod and the CMT pull-in
tool.
over the shaft protection hose
over the hosepack components
lead and LHSB cable plugs
distance as the motor lead (15)
the CMT pull-in tool