Torch neck coupling
Position of the
module in the
device
Position of the module in the device
Overview
Torch neck coupling: Components
Function over-
Outlet piece with inlet/outlet nozzle
view
The outlet piece (1) with screwed in inlet/outlet nozzle (2) is used to route the welding
wire from the drive unit to the coupling. The inlet/outlet nozzle is directly in front of the
drive unit feed rollers during the welding operation. This means the welding wire is
guided in the best possible way.
Robacta waterstop set
The Robacta (3) waterstop set is used to seal the water flow and return and prevents
coolant from leaking out.
Torch neck holder
The torch neck holder (4) is the interface to the torch neck: The holder passes on the
welding current, as well as all incoming leads, to the torch neck.
(1)
(2)
(3)
(1) Outlet piece
(2) Inlet/outlet nozzle
(3) Robacta waterstop set
(4)
(4) Torch neck holder
12