CMT hose coupler
Position of the
module in the
device
Position of the module in the device
Components
CMT hose coupler: Components
Function over-
CMT hose coupler
view
The CMT hose coupler (2) is the joint between the drive unit and the hosepack. The
CMT hose coupler (2) is used firstly to attach the hosepack and secondly to act as a
cover for the rear section of the drive unit. The CMT hose coupler (2) is attached to the
drive unit by 2 x M4 x 10 mm (3) Allen screws. Three O-rings (1) between the drive unit
and the CMT hose coupler (2) protect the motor, LHSB and robot cut-out box connec-
tors.
(1)
(2)
(1) O-ring
(2) CMT hose coupler
(3) M4 x 10 mm Allen screw
(3)
16