How Do You Change The Bulb; What Do You Do In Case Of Operating Malfunctions - DeDietrich DOP490 Serie Betriebsanleitung

99633843_ML_A 15 juin.qxd
H
o w d o y o u c h a n g e t h e b u l b ?
• The bulb is located on the ceiling of your oven's cavity.
Disconnect your oven before performing any task on the bulb to
avoid the risk of electric shock and, if necessary, let the appliance
cool down.
a) Unscrew the view port (see adjacent
diagram).
b) Remove the bulb.
Halogen bulb specifications:
- 25 W
- 220-240 V
- 300°C
- G9
c) Replace the bulb then reposition the
view port and reconnect your oven.
W
hat do you do in case of operating malfunctions?
If you have a doubt about the functioning of your oven, this does
not necessarily mean that there is a malfunction. In any event,
check the following items:
Y
ou notice that...
The oven is not heating.
The temperature indicator is
flashing.
The oven light is not working.
The pyrolysis cleaning cycle does
not begin.
Your oven starts beeping.
Your oven displays
80
15/06/2005 17:08
P
ossible causes
• The oven is not connected.
• The fuse in your electrical set-up is
not working.
• The selected temperature is too
low.
• Problem with the door's locking
mechanism.
• The light is out of order.
• The oven is not connected or the
fuse is not working.
• The door is not properly closed.
• The locking system is defective.
+ -
• During cooking.
Réglages
• At the end of a cooking pro-
gramme.
• When the touch controls are
pressed.
• Controls are locked for child safety.
Page 80
Bulb
Unscrew
View port
W
hat should you do?
- Connect the oven.
- Replace the fuse in your electrical
set-up and check its capacity (16A).
- Increase the selected temperature.
- Call the After-Sales Service
Department.
- Replace the light.
- Connect the oven or replace the
fuse.
- Verify that the door is locked.
- Call the After-Sales Service
Department.
- The recommended temperature
of your choice has been reached.
- Your programmed cooking cycle is
finished.
- Working normally.
- To eliminate it, press the selector
button and select "Unlock".