How Do You Program A Pyrolysis Cycle - DeDietrich DOP490 Serie Betriebsanleitung

99633843_ML_A 15 juin.qxd

3. How do you program a pyrolysis cycle?

Remove the grids and trays from the oven and clean any major spill
residue.
Select "Cleaning" from the main menu. Your oven
indicates the dirtiness of the cavity and suggests two
cleaning modes: Pyromax and Pyrocontrol.
Choose the appropriate setting:
a) Pyromax
· Pyromax is a pyrolysis system with a pre-set
duration: it lasts two hours and allows for thorough,
intensive cleaning of the oven cavity.
To delay the start time, select the end time and
change it by entering the desired end time for the pyrolysis cycle.
Note: If you entered the information on off-peak hours and peak hours
(see Settings function), your oven recommends a cleaning cycle during off-peak
hours to save energy. However, you can change this recommendation by changing
the end of pyrolysis time and starting the cleaning cycle immediately if you
choose.
Enter by pressing "OK"
The cleaning cycle begins. Your screen indicates:
- Time (1)
- Total duration (2)
- Time remaining (3)
- Pyrolysis cycle end time (4)
- Locked door (5)
b) Pyrocontrol
· PYROCONTROL is a system that lets the oven
automatically calculate the cleaning time depending
on the amount of dirtinessl, which makes it possible
to save energy by adjusting the pyrolysis time to
actual need. If you with to delay the start time,
select the end time and change it by entering the
desired end time for the pyrolysis cycle.
Enter by pressing "OK".
78
15/06/2005 17:08
How do you clean the cavity of your oven?
Page 78
Niveau de salissure
Level of dirtiness
Pyromax
Pyromax
2 hours
2:00
(2)
PYROCONTROL
PYROCONTROL
(1)
16:45
(5)
17:30
(4)
(3)