X-Ray Cassette Holder - Fa64205 - Stryker InTouch Bedienungsanleitung

X-Ray Cassette Holder - FA64205

The Optional X-Ray Cassette Holder was designed to hold the necessary material in order to perform X-Rays with the
bed .
INSTALLATION
Required Tools:
• #2 Phillips Screwdriver
1 . Raise the fowler to the full upright position .
2 . Apply the brakes if they are not already engaged .
3 . Unplug the bed and turn off the battery disconnect switch .
4 . Using a Phillips screwdriver, install the bracket assembly (A) to the the top of the fowler frame with two #10 x ½"
tapping screws (F) .
5 . Using a Phillips screwdriver, install the two Cassette Holder Pivot brackets (B) into the lower section of the fowler
with four #10 x ½" tapping screws (G) .
6 . Using the Phillips screwdriver, install the X-Ray Cassette Holder Plate (C) into the Cassette Holder Pivot brackets
(B) with two #10 x 3/4" tapping screws (E) and two spacers (D)
Note: Make sure to close the X-ray cassette holder support after using it to avoid damaging it when there is
a movement of the fowler section or of the list system.
B
D
Return To Table of Contents
1-78
G
E
D
A
F
2131-209-005 REV B
C
G
B
www.stryker.com