Zero Button - Stryker InTouch Bedienungsanleitung

MAIN MENU: SCALE (CONTINUED)

Zero Button

When the "Zero" button is pressed on the Scale
screen, Figure 5 .3 will be displayed .
If "Ok" is pressed, the bed will start zeroing the
scale and the "Do not touch bed" message will ap-
pear as shown in Figure 5 .4 .
If "Cancel" is pressed, the command will be
cancelled . If the bed gets into an auto shutoff at
this stage, the Zero request will be cancelled .
When the "Do not touch bed" message disappears,
Figure 5 .5 will be displayed .
When the zeroing of the scale is complete, Figure
5 .5 will be displayed .
Note
The "Zero" function will reset all the values for the
different patient's weights . All the data stored in the
touch screen concerning the weight of the patient
will be lost .
Return To Table of Contents
1-32
Footboard Operation Guide
Message
Message
2131-209-005 REV B
Scale Zero ?
Figure 5.3
Do not
touch bed
Figure 5.4
Message
Zero success !
Figure 5.5
Cancel Ok
Close
Close
www.stryker.com