Description Of Controls And Indicators - Fronius Roboterinterface Testing-System Bedienungsanleitung

Description of (38) "Gas Test" switch ...
controls and
indicators
(continued)
(39) "Blow through" switch ...
(40) "Welding simulation" switch ...
(41) "Source error reset" switch ...
(42) "Reserve parameter" switch (not active)
(43) "Touch sensing" switch (for ROB 5000) ...
(44) "Job / Program select" switch (for ROB 5000, not active)
(45) Indicator/selector "Operating bit 0-2" ...
For initialising the digital input signal "Gas test"
MIG/MAG:
For initialising the digital input signal "Blow through"
TIG:
For initialising the digital input signal to change between the following parameters
(Parameter switch):
- Welding current 1 / Welding current 2
- Wire feeder 1 / Wire feeder 2
For initialising the digital input signal "Welding simulation"
For initialising the digital input signal "Source error reset"
For initialising the digital input signal "Touch sensing"
Important! The "Job / Program select" switch must always be in the lower position.
To switch over between using the indicator/selector "Job / Program BIT 0-7" (46) for
selecting either program numbers or job numbers, the indicator/selector "Operating
bit 0-2" (45) must be actuated.
Indicator/selector (45) shows "0" or "1" (i.e. either "Standard program" or "Pulsed-arc
program" mode is selected):
- Indicator/selector (46) is used here for selecting the required program number
Indicator/selector (45) shows "3" (Job mode):
- Indicator/selector (46) is used here for selecting the required job number
For decimal definition of the significant states of the three binary input signals
"Operating bit 0" (Mode 0) up to "Operating bit 2" (Mode 2) (e.g. "2 decimal" = "010
binary")
Important! You will find a table for converting decimal numbers to binary numbers in
the section headed "Decimal / binary / hexadecimal numbers"
9