10 Checking the ride-on mower
10.4
Checking the fuses
NOTICE
If a new fuse already fails after a short while: It is
defective.
► Do not use the ride-on mower and instead
contact a STIHL authorized dealer.
Checking the plug-in fuses
► Place the ride-on mower on a level surface.
► Shut off the engine,
► Activate the parking brake,
► Remove the ignition key and store it securely.
► Remove the steering column cover,
15.7.1.1.
► Pull out the plug-in fuses (1).
► Check the wire (2) for damage.
► If the wire is damaged (2a): Replace the fuse
in accordance with the technical data,
► Install the steering column cover,
Checking the main fuse
► Place the ride-on mower on a level surface.
► Shut off the engine,
► Activate the parking brake,
► Remove the ignition key and store it securely.
► Remove the steering column cover,
15.7.1.1.
► Press the tabs (1) to the rear and open the
cover (2).
0478-193-9806-A
9.2.
11.5.1.
18.1.
15.7.1.2.
9.2.
11.5.1.
► Check the fuse (3) for damage.
► If the fuse is damaged (3a): Have the fuse
replaced by a STIHL authorized dealer.
► Close the cover.
The cover snaps into place.
► Install the steering column cover,
10.5
Checking the blade
► Place the ride-on mower on a level surface.
► Shut off the engine,
► Engage the parking brake,
► Remove the ignition key and store it securely.
► Detach the mowing deck,
► Lean the mowing deck (1) against a wall and
secure it against slipping.
► Clean the mowing deck and blade,
► Check the thickness (a) of the blade (2) in at
least 3 places.
If the blades are below the required minimum
thickness: Replace the blade,
► Check the width (b) of the blade (2) in at least
3 places.
If the blade is below the required minimum
width: Replace the blade,
English
15.7.1.2.
9.2.
11.5.1.
6.4.3.
14.1.
18.2.
18.2.
65