Demonstration; Example 1: Measurement A Simple Signal - Vevor Sds1102 Benutzerhandbuch

6. Demonstration

Example 1: Measurement a Simple Signal

The purpose of this example is to display an unknown signal in
the circuit, and measure the frequency and peak-to-peak voltage
of the signal.
1. Carry out the following operation steps for the rapid
display of this signal:
(1) Set the probe menu attenuation coefficient as 10X and that
of the switch in the probe switch as 10X (see "How to Set the
Probe Attenuation Coefficient" on P20).
(2) Connect the probe of Channel 1 to the measured point of
the circuit.
(3) Push the Autoset button.
The oscilloscope will implement the Autoset to make the
waveform optimized, based on which, you can further regulate
the vertical and horizontal divisions till the waveform meets your
requirement.
2. Perform Automatic Measurement
The oscilloscope can measure most of the displayed signals
automatically. To measure the period, the frequency of the CH1,
following the steps below:
(1) Push the Measure button to show the right menu.
(2) Select AddCH1 in the right menu.
(3) In the left Type menu, turn the M knob to select Period.
(4) In the right menu, select AddCH1. The period type is added.
79